Lldp Reinit; Lldp Tx-Delay - Cisco 300 Series Cli Manual

Link Layer Discovery Protocol (LLDP) Commands
78-21075-01 Command Line Interface Reference Guide
Example
The following example sets the LLDP packet hold time interval to 90 seconds.
switchxxxxxx(config)#
switchxxxxxx(config)#
37.6

lldp reinit

Use the lldp reinit Global Configuration mode command to specify the minimum
time an LLDP port waits before reinitializing LLDP transmission. Use the no form of
this command to revert to the default setting.
Syntax
lldp reinit seconds
no lldp reinit
Parameters
reinit seconds —Specifies the minimum time in seconds an LLDP port waits before
reinitializing LLDP transmission.(Range: 1–10)
Default Configuration
2 seconds
Command Mode
Global Configuration mode
Example
switchxxxxxx (config)# lldp reinit 4
37.7

lldp tx-delay

Use the lldp tx-delay Global Configuration mode command to set the delay
between successive LLDP frame transmissions initiated by value/status changes
in the LLDP local systems MIB. Use the no form of this command to restore the
default configuration.
lldp timer 30
lldp hold-multiplier
3
37
605