Dot1X Timeout Silence-Period - Cisco 300 Series Cli Manual

2
69
Default Configuration
The default timeout period is 30 seconds.
Command Mode
Interface (Ethernet) Configuration mode
User Guidelines
The actual timeout period can be determined by comparing the value specified by
this command to the result of multiplying the number of retries specified by the
radius-server retransmit
radius-server retransmit
Example
The following example sets the time interval between retransmission of packets to
the authentication server to 3600 seconds.
switchxxxxxx(config)#
switchxxxxxx(config-if)#

2.23 dot1x timeout silence-period

To set the authentication silence time, use the dot1x timeout silence-period
command in Interface Configuration mode. The silence time is the number of
seconds that if an authorized client does not send traffic during this period, the
client is changed to unauthorized
To return to the default setting, use the no form of this command.
Syntax
dot1x timeout silence-period
no dot1x timeout silence-period
Parameters
•
seconds
—Specifies the silence interval in seconds. The valid range is 60 -
65535.
command by the timeout period specified by the
command, and selecting the lower of the two values.
interface gi11
dot1x timeout server-timeout
seconds
OL-32830-01 Command Line Interface Reference Guide
802. 1 X Commands
3600