Dot1X Traps Authentication Failure - Cisco 300 Series Cli Manual

802. 1 X Commands
OL-32830-01 Command Line Interface Reference Guide
Command Mode
Interface (Ethernet) Configuration mode
User Guidelines
The default value of this command should be changed only to adjust to unusual
circumstances, such as unreliable links or specific behavioral problems with
certain clients and authentication servers.
The command is only applied to the 802.1x authentication method.
Example
The following command sets the time interval during which the device waits for a
response to an EAP request/identity frame to 60 seconds.
switchxxxxxx(config)#
switchxxxxxx(config-if)#

2.26 dot1x traps authentication failure

Use the dot1x traps authentication failure Global Configuration mode command to
enable sending traps when an 802.1X authentication method failed. Use the no
form of this command to return to the default.
Syntax
dot1x traps authentication failure {[802.1x] [mac] [web]}
no dot1x traps authentication failure
Parameters
•
802.1x—Enables traps for 802.1X-based authentication.
•
mac—Enables traps for MAC-based authentication.
•
web—Enables traps for WEB-based authentication.
Default Configuration
All traps are disabled.
interface gi11:
dot1x timeout tx-period
60
2
72