Gestetner A294 Service Manual page 597

Mode No.
(Class 1, 2 and 3)
2-911 Transfer Current On/Off Timing
2 Lb (On/Off
exchange
timing)
2-940 Leading Edge Transfer Current Adjustment
1 Tray-1
2 Tray-2
3 Tray-3
4 Tray-4 (LCT)
5 Tray-5 (LCT)
6 Tray-6 (LCT)
7 Duplex Tray
2-941 Transfer Current for Semi-thick Paper
2-968 Toner Density Correction
2-970 Toner Suction System
2-971 Collected Toner Level Check
Check this mode when "Waste toner full" pop-up message comes up or "Near full"
message is displayed.
1 Left Toner
Collection Bottle
2 Toner
Collection Bottle
SM
CÓPIA NÃO CONTROLADA
DIFFERENCES FROM THE A294 I / A295 I MODELS
Function
Adjusts the transfer current on/off
exchange timing.
B
(A294/A295 II models only)
Adjusts the leading edge transfer current
for each paper feed station.
(A294/A295 II models only)
B
Determines that the transfer current for
semi-thick paper is handled as Plain paper
or Thick paper
• Setting this mode to "Thick paper" is
effective when image at the leading edge
is not good.
• To use this mode, "Recycled paper"
B
should be selected in the User Tools for
semi-thick paper.
• Selecting "Thick paper" in the User Tools
is the same effect as this mode. But
selecting "Thick paper" in the User Tools
does not allow the duplex or punch
mode.
To prevent the image density dropping
during continuous copying after a long
interval (this is caused by a sudden
increase of Q/M), V
B 0.06 V every (100 X (SP2-974 value + 1))
prints. This correction is applied from when
the auto process control is done, until "(the
number of prints set in this SP mode) X
(SP2-974 value +1)" has been made.
Displays whether the toner suction system
is installed in order to distinguish between
A294/A295 I and A294/A295 II.
Display whether the used toner collection
bottle is full or not.
Display whether the sucked toner collection
bottle is full or not.
(A294/A295 II models only)
11-11
CÓPIA NÃO CONTROLADA
is changed by –
REF
Settings
[A294/A295 II]
0 ~ +60
1 mm/step
+45 mm
10 ~ 200
1 µA/step
[A294 II]
120 µ µ µ µ A
[A295 II]
140 µ µ µ µ A
0: Plain paper
1: Thick paper
0 ~ 20 k
1 k prints/step
0
[A294/A295 I]
0: Not installed
[A294/A295 II]
1: Installed
0: Not full
2: Full
0: Not full
1: Near full
2: Full
A294/A295