Gestetner A294 Service Manual page 357

Scanner Drive Wires (Front and Rear)
A294R014.WMF
1. Remove the wire tension bracket [A] (1 screw).
2. Remove the front scanner wire bracket [B].
3. Remove the front scanner wire.
Reinstallation
4. Remove the scanner wire pulley [C] (1 screw).
5. While making sure of the direction, place the beads on the middle of the wire
on the pulley openings. Then wind the wire (ball side) 3 times and the other
side (ring side) once as shown
condition.
6. Install the pulley on the scanner drive shaft (1 screw).
7. Wind the end of the wire with the ball as shown (
8. Wind the end of the wire with the ring as shown (
9. Install the tension spring on the tension bracket, and slightly tighten the tension
bracket (1 screw).
SM
CÓPIA NÃO CONTROLADA
℘ ℜ
ℑ
[C]
ℵ
ℵ
. Secure the pulley with tape to keep this
6-27
CÓPIA NÃO CONTROLADA
⊕
[B]
∅
ℑ ℜ ℘
, , and ).
⊗ ⊕ ∅
, , and ).
SCANNER UNIT
[A]
⊗
A294R013.WMF
A294/A295