Gestetner A294 Service Manual page 273

Rev. 9/2001
Mode No.
(Class 1, 2 and 3)
5-922 Subtract Optional Counter Setting
5-923 Border Erase Area Selection
5-924 Margin Per Original
1 Margin Per
Original
2 Per Original
Priority
5-954 Copy Server Password Check
5-965 Delete All the Saved Files
SM
CÓPIA NÃO CONTROLADA
Function
Selects whether machine immediately
stops when credit becomes 0 (zero).
S 0: Machine immediately stops.
1: Papers, which already started when
credit becomes 0 (zero), can be fed out.
Selects the standard for edge erase.
0: The margin is erased from the original
data.
1: The margin is erased from the data sent
S
to the laser diode.
Note: The output resulting from each of the
settings will be different when
reduction/enlargement is used.
Margin adjustment for each scanned
S
original can be adjusted when the settings
of the following SP modes.
This change was a result of special
requests from the Japanese domestic
market. The following remarks will be
added as machine limitations. As a general
rule, the settings should not be changed.
• Printing productivity for the 1st set of
originals will be decreased after the
margin is adjusted.
• The margin in Magazine Mode and in
Combine Mode cannot be adjusted in
this SP mode.
• After scanning an original in the sample
S
copy mode or after select setting key is
pressed when printing file using the
document server, the margin adjust key
can be changed. However, the key
changed will not affect any margin
adjustment.
• When different margins are selected for
the front original and rear original in
Designate or Chapter Mode (Duplex
copy), copying may not meet the
expectation.
• When the margin is changed in Tab
Sheet in Tab Mode, copying may not
meet the expectation.
If "1" is selected, when a file in the copy
S server is selected, the password for that file
is displayed.
Deletes all the copy server files stored in
the HDD.
4-51
CÓPIA NÃO CONTROLADA
SERVICE PROGRAM MODE
Settings
0: Normal
1: Productivity
0: Original
Standard
1: Copy
Standard
NO
YES
0: OFF
1: ON
0: Normal
1: Display the
password.
A294/A295