Gestetner A294 Service Manual page 245

Rev. 9/2001
Mode No.
(Class 1, 2 and 3)
2-941 Transfer Current for Semi-thick Paper
2-961 Developer Initialization (Factory)
2-962 Auto Process Control
2-966 Periodical Auto Process Control
2-967 Auto Image Density Adjustment
SM
CÓPIA NÃO CONTROLADA
Function
Determines that the transfer current for
semi-thick paper is handled as Plain paper
or Thick paper
• Setting this mode to "Thick paper" is
effective when image at the leading edge
is not good.
• To use this mode, "Recycled paper"
B
should be selected in the User Tools for
semi-thick paper.
• Selecting "Thick paper" in the User Tools
is the same effect as this mode. But
selecting "Thick paper" in the User Tools
does not allow the duplex or punch
mode.
Factory use only.
Automatically adjusts the following process
control factors.
1. Drum potential sensor
2. ID sensor
3. Charge grid voltage (by changing V
4. LD power (by changing V
B
Before using this SP, auto process control
should be on (SP3-901).
After changing the drum, ID sensor, drum
potential sensor, LD unit, charge corona
wires, or toner density sensor, this SP
should be used.
Selects whether auto process control is
done after the first job since 24 hours is
finished. This setting is required for a
B
customer who keeps the main switch on all
day.
Selects whether auto image density
adjustment is done during machine warm
up. This mode is to counter dirty
background that occurs when a machine is
used in an area that contains ammonia.
If Periodical Auto Process Control (SP2-
966) is used, this adjustment is done also
after the auto process control is finished.
B
4-23
CÓPIA NÃO CONTROLADA
SERVICE PROGRAM MODE
Settings
0: Plain paper
1: Thick paper
Start
)
D
)
H
ON
OFF
OFF
ON
A294/A295