Gestetner A294 Service Manual page 275

Rev. 9/2001
Mode No.
(Class 1, 2 and 3)
6-008 ADF Output Check
6-009 DF Free Run (Two-sided Original)
6-016 ADF Motor Speed Adjustment
6-105 Staple Position Adjustment
6-107 Finisher Free Run
1 Staple Mode
2 Shift Mode
6-113 Punch Hole Position Adjustment
6-116 Sheet Conversion (Thick Paper)
6-117 Finisher Input Check
1 Group 1
2 Group 2
3 Group 3
SM
CÓPIA NÃO CONTROLADA
Function
Turns on the electrical components of the
ADF individually for test purposes.
See the "Output Check" section for details.
Performs an ADF free run in two-sided
original mode. Press "1" to start.
This is a general free run controlled from
the copier. For more detailed free run
modes, see the 'Test Points/Dip
Switches/LEDs' section.
After pressing the Start key, the machine
automatically adjusts the speeds of the
ADF motors in the following order:
Feed-in motor → Transport Belt Motor →
Feed-out Motor (High) → Feed-out Motor
(Low)
Adjusts the stapling position in the main
scan direction
B Use the "•" key to toggle between + and –.
A larger value causes the stapling position
to shift outward.
The finisher simulates staple mode
operation. Press [1] to start the free run. To
stop the free run, press [0].
The finisher simulates staple mode free run
with tray shifting (without stapling). Press
[1] to start the free run.
Adjusts the punch hole position in the sub-
scan direction for the punch unit.
B Use the "•" key to toggle between + and –.
A larger value shifts the punch holes
towards the edge of the paper.
Multiply the normal limit by this number to
B determine the staple limit number for thick
paper mode.
Displays the signals received from sensors
and switches of the finisher.
See the "Input Check" section for details.
Displays the signals received from sensors
and switches of the finisher.
See the "Input Check" section for details.
Displays the signals received from sensors
and switches of the finisher.
See the "Input Check" section for details.
4-53
CÓPIA NÃO CONTROLADA
SERVICE PROGRAM MODE
Settings
OFF
ON
–1~ +3.5
0.5 mm/step
+0.0 mm
–7.5 ~ +7.5
0.5 mm/step
0 mm
1 ~ 3
3
A294/A295