Gestetner A294 Service Manual page 507

Rev.10/2000
⇒
A294 / A295 FIRMWARE MODIFICATION HISTORY
DESCRIPTION OF MODIFICATION
•
The margin in Magazine Mode and in
Combine Mode cannot be adjusted in this
SP mode.
• After scanning an original in the sample
copy mode or after select setting key is
pressed when printing file using the
document server, the margin adjust key
can be changed. However, the key
changed will not affect any margin
adjustment.
•
When different margins are selected for
the front original and rear original in
Designate or Chapter Mode (Duplex
copy), copying may not meet the
expectation.
•
When the margin is changed in Tab Sheet
in Tab Mode, copying may not meet the
expectation.
6. Increase tolerance against registration
motor torque.
A Registration sensor jam (SP7-504-63) with
duplex tray feed has been reported from the
Japanese domestic field. When the paper
buckle (adjustment: SP1-003-3) in the
registration nip is too high, Z fold jams may
occur. The tolerance against the registration
motor torque has been increased by this
firmware update. After updating the firmware,
check the registration from the duplex tray
(SP1-001-2).
7. Illuminating SC306 detection
Mis-detection of SC306 (Charge corona wire
cleaner connector is not connected).
Illuminating the unnecessary detection
(SC306:Charge corona wire cleaner
connector is not connected). This condition
can be detected with updating the firmware by
SC305 (Charge corona wire cleaner error 1).
SC306 was detected by malfunction in the
Japanese domestic field. The wire cleaner
was stopped in the middle of the charge
corona unit. Thus, the black line appeared in
the copy image. After the opening and closing
the copier door or switching off and on the
main switch, the cleaner was returned to the
home position.
SM
CÓPIA NÃO CONTROLADA
FIRMWARE
LEVEL
7-49
CÓPIA NÃO CONTROLADA
FIRMWARE HISTORY
SERIAL FIRMWARE
NUMBER VERSION
Continued..
A294/A295