Gestetner A294 Service Manual page 513

Rev. 06/2002
A294 / A295 FIRMWARE MODIFICATION HISTORY
.
Title
No
⇒
1 A294-II/A295-II
models
2 Slip sheet does
not function
properly when
using more than
256 pages in
connect copy
mode
3 Slip sheet does
not function
properly when
using specified
trays in chapters
mode
4 Productivity
improvement
when using LCT
5 Improvement of
"B4: registration"
paper misfeed
removal
6 Tray 1 (tandem
tray): paper mis-
set detection
SM
CÓPIA NÃO CONTROLADA
DESCRIPTION OF MODIFICATION
This version onward should be installed
on the A294-II/A295-II models. This
firmware is commonly used on both
A294/A295 and A294-II/A295-II models.
The new I/O board can recognize what
the model is and automatically uses the
appropriate software for the model.
When using more than 256 pages of
original in the connect copy mode, the
slip sheet does not function properly for
Page 256 and later on the sub-unit only.
When you specify the tray for 2 chapters
consecutively in the chapters mode and
the 1-side to 2-side duplex mode. The
first page of the second chapter is
printed on the back side of the last page
of the first chapter if the number of
pages for the first chapter is odd.
The feeding timing of the LCT has been
improved when changing the tray to
another within the LCT.
When a paper misfeed occurs at the
fusing or paper exit section, the paper
just fed out from the LCT stops at
registration with an accordion shape. It
is difficult to remove it.
So, the LCT relay clutch does not turn
on when such a jam occurs to prevent
the paper stopping at registration from
becoming an accordion shape.
When the right tray of Tray 1 is only set,
the machine does not check the
positions of the fences, so that even if
papers are wrongly set and the fences
are not at the closing positions, the
bottom tray is lifted up.
It should be checked and "Please re-set
papers" message should be displayed.
7-55
CÓPIA NÃO CONTROLADA
FIRMWARE HISTORY
SERIAL SOFTWARE
NUMBER VERSION
A2945609/ 8.2
A2945269
Continued
A294/A295