6.8.7 BOTTOM PLATE LIFT WIRE REPLACEMENT
NOTE: Before replacing the rear bottom plate lift wire, remove the front bottom
plate lift wire. The procedure for the two wires is the same.
A294R709.WMF
1. Remove the right tandem tray [A]. (Refer to Paper Tray Removal.)
2. Remove the inner cover (2 screws). (See Right 1st Tray Paper Sensor
Removal.)
3. Remove the sensor bracket [B] (3 screws).
4. Slightly lift the front bottom plate and unhook the wire stoppers [C] (1 stopper
[D] and 1 actuator [E]).
5. Remove the wire covers [F] (1 E-ring each).
6. Remove the bracket [G] (1 screw, 1 E-ring, and 1 bushing).
7. Remove the gear [H].
8. Replace the bottom plate lift wire [I].
SM
CÓPIA NÃO CONTROLADA
[A]
[C]
6-67
CÓPIA NÃO CONTROLADA
[F]
[H]
[G]
[I]
[D]
[E]
A294R712.WMF
PAPER FEED
[B]
A294/A295