Gestetner A294 Service Manual page 270

SERVICE PROGRAM MODE
Mode No.
(Class 1, 2 and 3)
5-121 Counter Up Timing
5-127 APS Mode
5-131 Paper Size Type Selection
5-212 Paper Print Setting
3 Page Print
Position Side -
Side to Side
4 Page Print
Position Up and
Down
5-501 PM Alarm Interval
5-504 Jam Alarm Interval (RDS Function)
1 Jam Alarm
Level
2 Jam Alarm
Long Time
5-505 Error Alarm (RDS Function)
SM
CÓPIA NÃO CONTROLADA
Determines the key counter count up
timing.
0: The key counter counts up at paper feed
timing.
S
1: The key counter counts up when the
paper exits to the finisher tray.
This setting does not affect the timing of the
copier total counter.
Selects the availability of APS mode.
S 0: APS can be used
1: APS cannot be used
Selects the paper size type (for originals
and copy paper). (The default setting
depends on the settings of DIP SW 1 and 2
B
on the SICU.)
After changing the value, turn the main
power switch off and on.
Adjusts the page print position for the
S reverse side when compared to the front
side. –10 (To the right) ~ 10 (To the left)
Adjusts the page print position for the
S reverse side when compared to the front
side. –10 (Upper) ~ 10 (Lower)
Set the PM alarm interval. A message is
displayed on the screen when the PM
counter reaches this value x 1,000.
The message can be turned off by the
S
following procedure: Clear Modes key – 0 –
Clear key – 0 – Clear key (hold for more
than 3 seconds). However, the PM counter
is not cleared. To clear the PM counter, use
SP7-804.
Japanese version only. Do not change
the setting.
S
Japanese version only. Do not change
S
the setting.
Japanese version only. Do not change
the setting.
S
4-48
CÓPIA NÃO CONTROLADA
Function
Rev. 9/2001
Settings
0: Feed
1: Exit
0: Yes
1: No
0: Japan
1: North
America
2: Europe
3: China
–10 ~ 10 mm
1 mm/step
0
–10 ~ 10 mm
1 mm/step
0
0 ~ 999 (k)
0 (No PM
Alarm)
0: Z
1: L
2: M
3: H
0: OFF
1: ON
0 ~ 255 (k)
30 k
A294/A295