Gestetner A294 Service Manual page 271

Rev. 9/2001
Mode No.
(Class 1, 2 and 3)
5-513 PM Call Interval (RDS Function)
1 Copy Paper
Standard
Original Paper
2
Standard
5-514 PM Call On/Off Setting
1 Copy Paper
Standard
2 Original Paper
Standard
5-590 Auto Call Setting (RSS Function)
2 Door Open
3 Paper Supply
4 Staple Supply
5 Toner Supply
5-801 Memory All Clear
1 ALL
2 SICU
3 BCU
5-802 Printer Free Run
5-803 Input Check
SM
CÓPIA NÃO CONTROLADA
Function
Japanese version only. Do not change
S the setting.
Japanese version only. Do not change
the setting.
S
Japanese version only. Do not change
S
the setting.
Japanese version only. Do not change
S
the setting.
Japanese version only. Do not change
S
the setting.
Japanese version only. Do not change
S
the setting.
Japanese version only. Do not change
S
the setting.
Japanese version only. Do not change
S
the setting.
Resets all correction data for process
control and all software counters. Also,
returns all modes and adjustments to the
default settings.
Settings for the SICU and BCU can be
cleared separately (marked with an S or a
B in the Mode No column of this table).
See the "Memory All Clear" section for how
to use this SP mode correctly.
Touch "Start" for over 3 seconds, then turn
the main power switch off and on.
Normally, this SP mode should not be
used.
It is used only after replacing the NVRAM,
or when the copier malfunctions due to a
damaged NVRAM.
The LCD coordinates are also cleared, see
"Touch Screen Calibration".
Press "On" on the display, then go to copy
mode.
Input the required settings, then press the
"Start" key to start the free run. The free run
stops when the simulation for the set
number of copies is finished.
Before starting the free run, disconnect the
finisher connector. Otherwise, a paper jam
is detected.
Displays the signals received from sensors
and switches.
See the "Input Check" section for details.
4-49
CÓPIA NÃO CONTROLADA
SERVICE PROGRAM MODE
Settings
0 ~ 9999 k
300 k
1 k step
0 ~ 9999 k
300 k
1 k step
0: No
1: Yes
0: No
1: Yes
0: OFF
1: ON
0: OFF
1: ON
0: OFF
1: ON
0: OFF
1: ON
Start
A294/A295