Gestetner A294 Service Manual page 514

FIRMWARE HISTORY
.
Title
No
⇒
7 SC398 just after
turning on new
CD-R/RW
8 LEF (long edge
feed) in booklet
and APS modes
on Plokmatic
Booklet Finisher
The following are additions and changes to the printer mode
9 Danish Names of
buttons are not
correct
10 Staple end
message
11 Full punch Dust
hopper message
12 Finisher shift
mode
A294/A295
CÓPIA NÃO CONTROLADA
A294 / A295 FIRMWARE MODIFICATION HISTORY
DESCRIPTION OF MODIFICATION
When the new CD-R/RW is turned on with
the following conditions, SC398 is
displayed.
•
The CD-R/RW is the new model
MP7122SE. There is no problem with
the model MP7040.
•
A media is in the CD-R/RW.
•
The CD-R/RW and engine are turned
on in order.
<Instruction to customers>
Please instruct customers with the
following procedure:
1. Turn on the CD-R/RW
2. Wait until the LED for the drive access
is turned off.
3. Turn on the engine.
On the Plokmatic Booklet Finisher, when
the booklet and APS modes are selected,
a paper with LEF direction is fed prior to
SEF. This is because the engine does not
recognize that the Plokmatic Booklet
Finisher is installed.
<Solution>
•
Set SP6902 (Booklet staple) to "Yes".
•
Set User Tools -> Copier/Document
Server Features -> General Features
-> Display/Panel Tone -> Staple
Position to "Bottom".
The above 2 settings make the engine
recognize that the "Bottom" staple means
the "Booklet" staple. The indication of
"Bottom" on the operation panel is not
changed.
Some Danish names of buttons have
been corrected. Please install the
language software (A2945125F, version
8.2) at the same time.
"Staple end. Please add staples" message
has been added.
"Punch dust hopper is full. Please throw it
away" massage has been added.
A message to set a shift mode to "for each
job and copy set", "for each job" or "no
shift", has been added to the SP mode.
CÓPIA NÃO CONTROLADA
7-56
Rev. 06/2002
SERIAL SOFTWARE
NUMBER VERSION
SM