6.7 TRANSFER BELT UNIT
6.7.1 TRANSFER BELT UNIT REMOVAL/INSTALLATION
[A]
A294R401.WMF
Removal
1. Turn off the main switch.
2. Remove the right inner cover (see Development Unit Removal).
3. Remove the transfer belt unit holder [A] (1 screw).
4. Disconnect the connector [B].
5. While turning the lever [C] counterclockwise, take out the transfer belt unit.
NOTE: 1) Do not touch the transfer belt with bare hands.
2) Take care not to scratch the drum with the transfer belt unit. Be careful
when installing the transfer belt unit.
Reassembly
1. While keeping the lever [C] rotated fully counterclockwise, install the transfer
belt unit.
NOTE: 1) Insert the gear [D] into the opening [E] in the rear frame.
2) Place the slot [F] in the transfer belt unit on the rail.
SM
CÓPIA NÃO CONTROLADA
[B]
6-51
CÓPIA NÃO CONTROLADA
TRANSFER BELT UNIT
[D]
[F]
[C]
A294R402.WMF
[E]
A294/A295