Gestetner A294 Service Manual page 190

COPIER (A294)
A294R520.WMF
[E]
[F]
9. Remove the drum stay knob [G] and the drum stay (turn the knob clockwise to
remove it).
10. Remove the tape and foam cushion from fusing unit.
11. Disconnect the two connectors [A].
12. Pull out the development unit [B] as shown.
NOTE: 1) To prevent scratches on the drum, push the development unit to the
right while pulling it out.
2) When pulling out the development unit, do not pull the knob [C].
3) Place the development unit on a clean sheet of paper, to prevent
foreign matter from being attracted to the sleeve rollers.
13. Remove the toner hopper [D] (2 screws).
14. Pour in one pack of developer [E] while turning the knob [F]. Distribute the
developer evenly along the development unit.
15. Attach the toner hopper to the development unit.
16. Install the development unit in the machine and connect two connectors.
NOTE: When reinstalling the development unit, confirm that the harness layout
is as shown [G].
17. Attach the drum stay and attach the drum stay knob and one screw.
18. Remove the right upper cover [A] (4 screws).
A294/A295
CÓPIA NÃO CONTROLADA
[C]
[D]
3-8
CÓPIA NÃO CONTROLADA
A294I010.WMF
[B]
[G]
[A]
SM