Gestetner A294 Service Manual page 508

FIRMWARE HISTORY
⇒
DESCRIPTION OF MODIFICATION
8. Default setting for SP1-002
We have learned that the new settings of SP
1-002 (side-to-side registration) meets better
the actual adjustment. In order to activate the
new default settings after you have installed
the firmware, you must enter the SP modes
and manually change the settings to the
following new default values. After this has
been done, the machine will recognize these
settings as default. If the side-to side
registration is within the specifications (2±1.5
mm), you do not have to change the settings.
Old
New
9. Transparencies & Translucent Sheet
As a result of a request from the field, the
terms used to describe OHP and tracing
paper in SP Mode descriptions have been
changed. Specifically:
Old / New:
OHP: transparencies
tracing paper: Translucent sheet
Old Titles:
SP2-001-4 "Grid Voltage for Transparent
Sheet"
SP2-201-3 "Transparent Sheet"
SP2-301-3 "OHP Sheet"
SP2-301-4 "Transparent Sheet" (translation
mistake)
New Titles:
SP2-001-4 "Grid Voltage for Transparencies"
SP2-201-3 "Transparencies"
SP2-301-3 "Transparencies"
SP2-301-4 Translucent Sheet"
10. 1st release for the printer controller
The 1st release for the mass production
machines of the printer controller. When the
printer controller unit is installed, it is
necessary to update the firmware. The
language card must also be updated to
A2945125A (V7.31.3).
A294/A295
CÓPIA NÃO CONTROLADA
A294 / A295 FIRMWARE MODIFICATION HISTORY
0 0
-1.5 -1.5
CÓPIA NÃO CONTROLADA
FIRMWARE
LEVEL
0 4th (LCT) 5th (LCT)
-1.5 0
-2.5
7-50
Rev. 10/2000
SERIAL FIRMWARE
NUMBER VERSION
6th (LCT)
0 0
-2.5 -2.5
Duplex
0
-3.0
SM