Gestetner A294 Service Manual page 487

Rev.9/2001
SC703: ADF Transport Belt Motor Error
Definition [B]
The transport belt motor does not turn properly.
Possible Causes
• Transport belt motor defective
• ADF main board defective
• Poor connection between the transport motor and ADF main board
• Too much load
SC704: ADF Feed-out Motor Error
Definition [B']
The feed-out motor does not turn properly
Possible Causes
• Feed-out motor defective
• ADF main board defective
• Poor connection between the feed-out motor and ADF main board
• Too much load
SC705: ADF Original Table Lift Malfunction
Definition [B]
One of the following conditions was detected.
1) The bottom plate position sensor does not activate when the original table
motor lifts the original table.
2) The bottom plate HP sensor does not activate when the bottom plate motor
lowers the original table.
Possible Causes
• Bottom plate H.P sensor defective
• Bottom plate motor defective
• ADF main board defective
• Bottom plate position sensor defective
SC720: Finisher Lower Transport Motor Error
Definition [B']
The lower transport motor does not turn properly
Possible Causes
• Lower transport motor defective
• Finisher main board defective
• Poor connection between the lower transport motor and finisher main board
• Too much load
SM
CÓPIA NÃO CONTROLADA
7-29
CÓPIA NÃO CONTROLADA
SERVICE CALL CONDITIONS
A294/A295