Punch Waste Collection - Gestetner A294 Service Manual

PUNCH WASTE COLLECTION

2.10 PUNCH WASTE COLLECTION
The punch waste is collected in the punch waste hopper [A], which is under the
punch unit.
When the punch waste covers the hole [B] in the hopper, the punch waste hopper
Þ
sensor [C] turns on and a message will be displayed in the operation panel LCD.
Then, the copy job will be stopped. After emptying the punch waste and returning
the punch waste hopper [A] to the finisher, the copy job will be resumed.
The punch waste hopper sensor also works as the hopper set sensor. If the punch
waste hopper is not set, the sensor stays away from the hole in the hopper holder
[D] and a message is displayed. This message is the same as for the hopper full
condition.
A294/A295
CÓPIA NÃO CONTROLADA
[B]
[A]
CÓPIA NÃO CONTROLADA
[C]
B302D002.WMF
8-18
Rev. 10/2000
[D]
SM