Gestetner A294 Service Manual page 343

Exit Sensor and Inverter Sensor
[A]
[B]
B301R509.WMF
Exit Sensor
1. Remove the front and rear covers.
2. Remove the exit guide unit [A] (4 screws).
3. Replace the exit sensor [B] (1 connector).
NOTE: When reinstalling the exit guide unit, make sure that the guide plate [C]
on the exit unit is over the exit gate [D].
Inverter Sensor
1. Remove the front and rear covers.
2. Remove the right lower cover [E] (4 screws).
3. Remove the guide plate [F] (3 screws).
4. Replace the inverter sensor [G] (1 connector).
SM
CÓPIA NÃO CONTROLADA
[D]
[C]
6-13
CÓPIA NÃO CONTROLADA
DOCUMENT FEEDER
[F]
[G]
[E]
B301R508.WMF
A294/A295