Gestetner A294 Service Manual page 415

Rev. 02/2000
[A]
[G]
A294R503.WMF
[L]
[M]
NOTE: Do not remove the four M4 bind screws [A] in the next step.
5. Remove the four M5 pan head screws [B] and remove the hot roller unit [C].
NOTE: 1) When re-installing the hot roller unit, make sure that the flanges of
the ball bearings in the hot roller unit are set inside the fusing exit
side plate [D] and the gear in the hot roller unit is installed on the
rear side.
⇒
2) Secure the M5 pan head screws in the following order: left-rear,
right-front, right-rear, left-front.
6. Remove the two bind screws [E] securing the pressure roller stripper unit [F].
7. Slide the pressure roller stripper unit [F] to the right while slightly raising the
side near the pressure roller (1 connector [G] and 1 clamp [H]).
NOTE: Be careful not to touch the pressure roller surface during this step.
8. Lift up the pressure roller unit [I].
9. Remove the C-ring [J] from the pressure roller and replace the pressure roller
[K] (2 ball bearings, 2 bushings).
NOTE: Lubricate the inner surface [L] of the pressure roller (bearing [M] contact
part) with BARRIERTA L55/2 grease when replacing the pressure roller.
SM
CÓPIA NÃO CONTROLADA
[B]
[B] [C]
[D]
[H]
A294R022.WMF
CÓPIA NÃO CONTROLADA
[A]: Do not remove these screws.
[A]
[E]
[F]
[I]
[J]
6-85
FUSING UNIT
[K]
[M]
A294R504.WMF
A294/A295
[M]