3.8 SIDE REGISTRATION ADJUSTMENT
NOTE: Normally the side registration of the image can be adjusted with SP mode.
When the punch hole positions are not aligned from a particular feed
station, adjusted the side registration by changing the tray cover position
for that tray, as described below. Then adjust the side registration of the
image with the SP mode.
1. Pull out the tray.
2. Change the screw positions [A] at both the right and left sides as shown.
Adjustment range: 0 ± 2.0 mm adjustment step: 1.0 mm/step
SM
CÓPIA NÃO CONTROLADA
9-21
CÓPIA NÃO CONTROLADA
SIDE REGISTRATION ADJUSTMENT
B303R112.WMF
[A]
A294/A295