Gestetner A294 Service Manual page 531

[B]
B302D517.WMF
The stapler has a staple end sensor [A], cartridge set sensor [B] and staple
hammer HP sensor [C].
When a staple end or no cartridge condition is detected, a message is displayed
advising the operator to install a staple cartridge. If this condition is detected during
a copy job, the indication will appear, and the copy job will stop.
The staple cartridge has a clinch area [D], in which jammed staples are left.
Operators can remove the jammed staples from this area.
When the operator lifts the release lever [E], the clinch area is released from the
cartridge by pushing the holders [F]. The jammed staples can be removed.
The staple sheet can be feed manually by sliding the knob [G].
SM
CÓPIA NÃO CONTROLADA
[C]
[A]
[D]
8-13
CÓPIA NÃO CONTROLADA
[E] [G]
B302D518.WMF
STAPLER
[F]
A294/A295