A294 / A295 Firmware Modification History - Gestetner A294 Service Manual

Rev.06/2002

A294 / A295 FIRMWARE MODIFICATION HISTORY

DESCRIPTION OF MODIFICATION
⇒
Software modified so that it can also be used
with the A295. (all versions from 7.40 can be
used on both A294 and A295B).
To make it possible to use the "Margin per
Original" function, the following 2 SP modes
have been added:
5924-1 (Margin per Original): Yes/No (default:
No).
5924-2 (Per Original Priority): On/Off (default:
Off).
Software changed so that the Web End
condition will not be detected until the display
for SP1902-1 (Web Consumption) has
reached 102%.
The display for Directional Size Magnification
has been changed from mm to inches for N.A.
models.
Software changed so that "Set the lower toner
bottle" is displayed at Toner Near End and
Toner End.
When printing out print documents saved on
the Copy Server onto index paper, part of the
image may be cut off. To correct this, the
software has been changed.
The setting ranges for fusing temperature-
related SP modes have been changed to the
following:
SP1105-1 (Fusing Temperature in Waiting
Condition):
85cpm (Bellini A): 168 to 178
105cpm (Bellini B): 173 to 178
SP1105-4 (Fusing Temperature Correction):
85/105cpm: -5 to +20
Software changed so that paper on the left
tray will not be shifted to the right tray after it
is pulled out while its bottom plate is lifting
(resulting in a Paper End mis-detection).
Software modified so that SP2114 will take on
the correct default value for each destination
after SP5801 (Memory All Clear) is
performed.
Previously, the NVRAM was properly
initialized following memory all clear and
power Off/On, however SP2114 was set to
the same value for all destinations (value for
Japanese models).
SM
CÓPIA NÃO CONTROLADA
Title
For use with the
A295 (105cpm)
Margin per
Original
Web End
detection
improved
Inch display for
Directional Size
Magnification
(N.A. machines
only)
Solution for
detached upper
toner bottle cap
Copy Server
index paper
printing
Fusing temp.
setting ranges
changed
SC515 (Tandem
Rear Fence Drive
Motor Error)
SP2114 (Printer
Dot Edge
Parameter
Setting)
initialization
correction
7-51
CÓPIA NÃO CONTROLADA
FIRMWARE HISTORY
SERIAL SOFTWARE
NUMBER VERSION
7.40
A2945604 K /
A2945264 K
7.44
A2945604 L /
A2945264 L
7.47
A2945604 M
/ A2945264M
A2945604 N / 7.49
A2945264 N
A294/A295