Gestetner A294 Service Manual page 268

SERVICE PROGRAM MODE
Mode No.
(Class 1, 2 and 3)
4-912 HDD 2 Rear (Gray)
1 HDD 2 Media
Check
2 HDD 2
Formatting
6 HDD 2 Bad
Sector
Information
Reset
7 HDD 2 Bad
Sector Display
8 HDD 2 Model
Name Display
4-913 HDD Interface Type Selection
4-914 Forced HDD Selection
4-915 CD-RW
1 CD-RW Model
Name Display
2 CD-RW F/W
Version Display
SM
CÓPIA NÃO CONTROLADA
Checks for bad sectors on hard disk 2 that
develop during machine use. This takes 4
minutes.
All the image data on this disk is erased,
and the stamp data is erased from both
disks.
This SP mode should be done when an
abnormal image is printed. There is no
need to do this at installation because the
hard disk firmware already contains bad
sector information, and damage is not likely
during transportation.
Bad sectors detected with this SP mode will
be stored in the NVRAM with the bad
sector data copied across from the
firmware.
If the machine detects over 50 bad sectors,
SC365 will be generated. At this time, use
SP4-912-2.
Formats hard disk 2. This takes 4 minutes.
Do not turn off the main power switch
during this process.
Resets the bad sector information which is
stored in the NVRAM.
This SP should be used when the hard disk
is replaced.
Displays the number of bad sectors there
are on hard disk 2.
S If the machine detects a total of over 50
bad sectors on the disk, SC365 will be
generated. At this time, use SP4-912-2.
Displays the model name of HDD 2.
If the HDD is not installed or the HDD
connector is not connected, SC361 will be
displayed. However, the user can make
single copies. (See Detailed Section
Descriptions – Others for details on the use
of the two hard disks.)
Designer use only. Do not change this
setting.
S
Designer use only. Do not change this
setting.
Displays the CD-RW model name.
Displays the CD-RW firmware version.
4-46
CÓPIA NÃO CONTROLADA
Function
Rev. 9/2001
Settings
Start
Total: 0
Copy: 0
Printer: 0
AF (Copy
Server): 0
0: Ultra
DMA/33 I/F
1: Multiword
DMA I/F
0: Default
1: HDD1
2: HDD2
A294/A295