Gestetner A294 Service Manual page 114

TONER SUPPLY AND RECYCLING
Toner Bottle Sensors
A294D912.WMF
When placing a toner bottle in the toner bank, the toner bottle pushes the lock arm
[A] downwards. Then the lock arm catches the toner bottle. Also, lever [B] is
pushed down, which causes the toner bottle sensor [C] to detect that a bottle has
been installed (the actuator leaves the toner bottle sensor while the bottle is being
inserted in the holder).
When replacing a toner bottle, push the toner bottle release lever [D] to release the
lock mechanism. When a toner bottle is being used to supply toner, the toner bottle
opening rod is pulled to the rear and the lock plate [E] is lowered by the link [F] so
that the toner bottle release lever cannot be pushed. Therefore, the toner bottle
that is supplying toner is locked in place.
Normally the user cannot pull out the bottle until it is empty but the bottle can also
be removed when the operation button is pressed (unit off) or when the unit enters
Energy Saver or Auto Off modes. During these periods the bottle is released and
the plug is replaced.
A294/A295
CÓPIA NÃO CONTROLADA
[A]
[C]
[B]
[F]
2-64
CÓPIA NÃO CONTROLADA
Rev. 2/2000
[D]
[E]
A294D914.WMF
A294D913.WMF
SM