Jrr200 Route Reflector Chassis Status Leds; Management Port Leds; Figure 2: Jrr200 Route Reflector Chassis Status Leds; Table 4: Jrr200 Route Reflector Chassis Status Leds - Juniper JRR200 Hardware Manual

Copyright © 2018, Juniper Networks, Inc.

JRR200 Route Reflector Chassis Status LEDs

Figure 2 on page 19 shows the chassis status LEDs that are located on the front panel
of the JRR200 route reflector.

Figure 2: JRR200 Route Reflector Chassis Status LEDs

Power
Status
SSD

Table 4: JRR200 Route Reflector Chassis Status LEDs

LED Description
Power Solid green—receiving power
Status Solid green—operating normally
Solid red—critical alarm
Hardware component failure
Software module failure
Fan failure (atleast one)
Blinking red—noncritical alarm
Off—the system is not receiving power
SSD Blinking green—indicates hard disk drive (SSD) activity

Management Port LEDs

The management port has two LEDs that indicate link activity and status of the
management port.
Table 5 on page 19 describes the LEDs.

Table 5: Management Port LEDs

LED Description
Link/Activity (LED Solid amber—A link is established, but there is no activity on the link.
on the left)
Blinking amber—There is link activity.
Off—There is no link established.
Speed (LED on the Solid green—100-Mbps link is established.
right)
Solid amber—1000-Mbps link is established.
Off—There is no link established.
Table 4 on page 19 describes the LEDs.
Chapter 1: Overview
19