Connecting Ac Power To An Ex2200 Switch - Juniper EX2200 Series Hardware Manual

Connecting AC Power to an EX2200 Switch

Copyright © 2011, Juniper Networks, Inc.
Connecting DC Power to an EX4200 Switch
Connecting AC Power to an EX4500 Switch
Connecting DC Power to an EX4500 Switch
Connecting AC Power to an EX6200 Switch
Connecting DC Power to an EX6200 Switch
Connecting AC Power to an EX8200 Switch
Connecting DC Power to an EX8200 Switch
General Safety Guidelines and Warnings on page 155
Grounded Equipment Warning on page 172
The power supply in an EX2200 switch is located on the rear panel.
Ensure that you have the following parts and tools available:
A power cord appropriate for your geographical location
A power cord retainer clip
Ensure that you have connected the switch chassis to earth ground.
CAUTION: To meet safety and electromagnetic interference (EMI)
requirements and to ensure proper operation, you must connect the switches
to earth ground before you connect them to power. For installations that
require a separate grounding conductor to the chassis, use the protective
earthing terminal on the switch chassis to connect to the earth ground. For
instructions on connecting earth ground, see
an EX Series Switch" on page
when you plug the power supply in the switch into a grounded AC power
outlet by using the AC power cord appropriate for your geographical location
(see "AC Power Cord Specifications for EX2200 Switches" on page
To connect AC power to the switch:
Squeeze the two sides of the power cord retainer clip and insert the L-shaped ends
1.
of the wire clip into the holes in the bracket on each side of the AC power cord inlet
on the rear panel (Figure 47 on page
The power cord retainer clip extends out of the chassis by 3 in.
Locate the power cord or cords shipped with the switch; the cords have plugs
2.
appropriate for your geographical location. See
EX2200 Switches" on page
"Connecting Earth Ground to
103. An EX2200 switch gets additional grounding
110).
"AC Power Cord Specifications for
66.
Chapter 10: Connecting the Switch
66).
109