Connecting Ac Power To An Ocx1100 Switch; Figure 25: Installing A Dc Power Supply In An Ocx1100-48Sx Switch - Juniper OCX1100 Hardware Manual

OCX1100 Switch Hardware Guide

Documentation

Connecting AC Power to an OCX1100 Switch

If the power supply slot has a cover panel on it, loosen the captive screws on the cover

panel by using your fingers or the screwdriver. Hold the captive screw and gently pull

it outward to remove the cover panel. Save the cover panel for later use.

Taking care not to touch power supply pins, leads, or solder connections, remove the

power supply from the bag.

Using both hands, place the power supply in the power supply slot on the rear panel

of the switch and slide it in until it is fully seated and the clip clicks into place. See

Figure 25 on page 80

NOTE:

If you have a Juniper J-Care service contract, register any addition,

change, or upgrade of hardware components at

https://www.juniper.net/customers/csc/management/updateinstallbase.jsp

Failure to do so can result in significant delays if you need replacement parts.

This note applies if you change the type of power supply or add a new type

of uplink module. It does not apply if you replace these components with the

same type of component.

Removing a DC Power Supply from an OCX1100 Switch on page 114

DC Power Supply in OCX1100 Switches on page 25

Connecting DC Power to an OCX1100 Switch on page 82

OCX1100 Switches Hardware Overview on page 3

The AC-powered models of (see

support 460 W AC power supplies. After you install at least one power supply, you can

connect power to the switch.

CAUTION:

Do not install:

"OCX1100 Switch Models" on page

6) OCX1100 switches

Table of Contents