Show Classofservice Ip-Precedence-Mapping; Show Classofservice Ip-Dscp-Mapping - NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-

13.1.9 show classofservice ip-precedence-mapping

This command displays the current IP Precedence mapping to internal traffic classes for a
specific interface. The slot/port parameter is optional and is only valid on platforms that
support independent per-port class of service mappings. If specified, the IP Precedence
mapping table of the interface is displayed. If omitted, the most recent global
configuration settings are displayed.
Note: The IP DSCP command mapping is only supported on the Broadcom 5695
Format
Mode
The following information is repeated for each user priority.
IP Precedence
Traffic Class

13.1.10 show classofservice ip-dscp-mapping

This command displays the current IP DSCP mapping to internal traffic classes for the
global configuration settings.
Format
Mode
The following information is repeated for each user priority.
IP DSCP
Traffic Class
13-6
platform.
show classofservice ip-precedence-mapping [slot/
port]
Privileged EXEC
The IP Precedence value.
The traffic class internal queue identifier to which the IP Pre-
cedence value is mapped.
show classofservice ip-dscp-mapping
Privileged EXEC
The IP DSCP value.
The traffic class internal queue identifier to which the IP
DSCP value is mapped.
v1.0, December 2005
Quality of Service (QoS) Commands