Console Port Access Commands; Configuration; Lineconfig; Section 3.2 "Console Port Access Commands - NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-
Subnet Mask
Default Gateway
ServPort

Configuration

Protocol Current
Burned in MAC
Address

3.2 Console Port Access Commands

This section describes the commands you use to configure the console port. You can use a
serial cable to connect a management host directly to the console port of the switch.
3.2.1 configuration
This command gives you access to the Global Config mode. From the Global Config
mode, you can configure a variety of system settings, including user accounts. From the
Global Config mode, you can enter other command modes, including Line Config mode.
Format
Mode

3.2.2 lineconfig

This command gives you access to the Line Config mode, which allows you to configure
various telnet settings and the console port.
Format
Mode
Administrative Access Commands
The IP subnet mask for this interface. The factory default
value is 0.0.0.0
The default gateway for this IP interface. The factory default
value is 0.0.0.0
Indicates what network protocol was used on the last, or cur-
rent power-up cycle, if any.
The burned in MAC address used for in-band connectivity.
configuration
Privileged EXEC
lineconfig
Global Config
v1.0, December 2005
3-5