This section describes the DHCP commands available in the 7300 Series Managed Switch
CLI. DHCP automatically allocates and manages client TCP/ IP configurations. DHCP
uses UDP as its transport protocol and supports a number of features that facilitate in
administration address allocations.
The DHCP Server Commands section includes the following topics:
•
Section 7.1 "DHCP Server Commands (DHCP Config Pool Mode)" on page 7-2
•
Section 7.2 "DHCP Server Commands (Global Config Mode)" on page 7-9
•
Section 7.3 "DHCP Server Clear and Show Commands" on page 7-12
•
Section 7.4 "DHCP and BOOTP Relay Commands" on page 7-16
The commands in this section are in one of three functional groups:
•
Configuration Commands are used to configure features and options of the switch. For
every configuration command there is a show command that will display the
configuration setting.
•
Show commands are used to display switch settings, statistics and other information.
•
Clear commands clear some or all of the settings to factory defaults.
DHCP Commands
v1.0, December 2005
Chapter 7
DHCP Commands
7-1