Using Cli Help - NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-
Table 2-8. CLI Editing Conventions
Key Sequence
Ctrl-S
Ctrl-Z
Tab, <SPACE>
Exit
?

2.2.7 Using CLI Help

Enter a question mark (?) at the command prompt to display the commands available in
the current mode.
(switch) >?
enable
help
logout
ping
show
Enter a question mark (?) after each word you enter to display available command
keywords or parameters.
(switch) #network ?
javamode
parms
protocol
mgmt_vlan
If the help output shows a parameter in angle brackets, you must replace the parameter
with a value.
(switch) #network parms ?
<ipaddr>
If there are no additional command keywords or parameters, or if additional parameters
are optional, the following message appears in the output:
<cr>
2-10
Description
Disables serial flow
Return to root command prompt
Command-line completion
Go to next lower command prompt
List available commands, keywords, or parameters
Enter into user privilege mode.
Display help for various special keys.
Exit this session. Any unsaved changes are lost.
Send ICMP echo packets to a specified IP address.
Display switch options and settings.
Enable/Disable.
Configure Network Parameters of the router.
Select DHCP, BootP, or None as the network config
protocol.
Configure the Management VLAN ID of the switch.
Enter the IP Address.
Press Enter to execute the command
v1.0, December 2005
Overview