Show Loginsession; Show Users - NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-
3.6.5.1 no users snmpv3 encryption
This command sets the encryption protocol to none. The
name for which the specified encryption protocol will be used.
Format
Mode

3.6.6 show loginsession

This command displays current telnet and serial port connections to the switch.
Format
Mode
ID
User Name
Connection From
Idle Time
Session Time

3.6.7 show users

This command displays the configured user names and their settings. This command is
only available for users with Read/Write privileges.
SNMP is available on the system.
Format
Mode
User Name
Access Mode
SNMPv3 Access
Mode
Administrative Access Commands
no users snmpv3 encryption <username>
Global Config
show loginsession
Privileged EXEC
Login Session ID
The name the user will use to login using the serial port or
Telnet.
IP address of the Telnet client machine or EIA-232 for the
serial port connection.
Time this session has been idle.
Total time this session has been connected.
show users
Privileged EXEC
The name the user enters to login using the serial port, Telnet
or Web.
Shows whether the user is able to change parameters on the
switch (Read/Write) or is only able to view them (Read
Only). As a factory default, the "admin" user has Read/Write
access and the "guest" has Read Only access. There can only
be one Read/Write user and up to five Read Only users.
This field displays the SNMPv3 Access Mode. If the value is
set to the SNMPv3 user is able to set and
ReadWrite,
v1.0, December 2005
is the login user
<username>
The SNMPv3 fields will only be displayed if
3-21