Neighbor Addrfamily; Neighbor <Peeripaddr> Authentication None - NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-
14.8.43.1 no enable (BGP)
This command disables the administrative mode of BGP4 on the system.
Format
Mode

14.8.44 neighbor addrfamily

This command assigns an Address Family with a Subsequent Address Family Identifier
(SAFI) to the peer. The AFI identifies a supported protocol, and the defined value is IP
version 4. The SAFI describes a sub-AFI value that is supported for the AFI. The possible
values for <
safi>
After executing this command, the BGP peer must be reset before the
labeldist.
changes will take effect.
Default
Format
Mode
14.8.44.1 no neighbor addrfamily
This command removes the Address Family with the assigned Subsequent Address
Family Identifier (SAFI). The AFI identifies a supported protocol, and is defined as IP
version 4. The SAFI describes a sub-AFI value that is supported for the AFI. The possible
values for <
safi>
After executing this command, the BGP peer must be reset before the
labeldist.
changes will take effect.
Default
Format
Mode
14.8.45 neighbor <peeripaddr> authentication none
This command configures the authentication type as none for a particular peer address,
which is the default setting.
Format
Mode
14-84
no enable
Router BGP Config
are
unicast, multicast, both-unicast-multicast
none
neighbor <peeripaddr> addrfamily <safi>
Router BGP Config
are
unicast, multicast, both-unicast-multicast
none
no neighbor <peeripaddr> addrfamily <safi>
Router BGP Config
neighbor <peeripaddr> authentication <none>
Router BGP Config
v1.0, December 2005
and
and
Routing Commands