Snmp-Server Enable Traps Stpmode; Snmptrap - NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-
10.1.12.1 no snmp-server enable traps multiusers
This command disables Multiple User traps.
Format
Mode

10.1.13 snmp-server enable traps stpmode

This command enables the sending of new root traps and topology change notification
traps.
Default
Format
Mode
10.1.13.1 no snmp-server enable traps stpmode
This command disables the sending of new root traps and topology change notification
traps.
Format
Mode

10.1.14 snmptrap

This command adds an SNMP trap receiver. The maximum length of
sensitive alphanumeric characters. The
version parameter options are snmpv1 or snmpv2.
The parameter does not need to be unique, however; the
<name>
pair must be unique. Multiple entries can exist with the same
associated with a different
The reverse scenario is also acceptable. The
sending the trap to the receiver, but the
Community Table. For more information, see
on page 10-2.
Default
Format
Mode
SNMP Commands
no snmp-server enable traps multiusers
Global Config
enabled
snmp-server enable traps stpmode
Global Config
no snmp-server enable traps stpmode
Global Config
<snmpversion>
.
<ipaddr>
<name>
is not directly associated with the SNMP
<name>
Section 10.1.2 "snmp-server community"
snmpv2
snmptrap <name> <ipaddr> [snmpversion <snmpver-
sion>]
Global Config
v1.0, December 2005
<name>
is the version of SNMP. The
and
<name>
as long as they are
<name>
is the community name used when
is 16 case-
<ipaddr>
10-7