Show Interface - NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-

18.1.4 show interface

This command displays a summary of statistics for a specific interface or a count of all
CPU traffic based upon the argument.
Format
Mode
Note: For information about the format and output for
The display parameters, when the argument is
Packets Received
Without Error
Packets Received
With Error
Broadcast
Packets
Received
Packets
Transmitted
Without Error
Transmit Packets
Errors
Collisions
Frames
Time Since
Counters Last
Cleared
18-4
show interface {<slot/port> | switchport | ether-
net}
Privileged EXEC
, see Section 18.1.5 "show interface ethernet" on page
ethernet
The total number of packets (including broadcast packets and
multicast packets) received by the processor.
The number of inbound packets that contained errors prevent-
ing them from being deliverable to a higher-layer protocol.
The total number of packets received that were directed to the
broadcast address. Note that this does not include multicast
packets.
Total number of packets transmitted out the interface.
Number of outbound packets that could not be transmitted
because of errors.
Best estimate of the total number of collisions on this Ether-
net segment.
Elapsed time, in days, hours, minutes, and seconds since the
statistics for this port were last cleared.
v1.0, December 2005
show interface
, is as follows:
<slot/port>
System Maintenance Commands
18-6.