Users Passwd; Users Snmpv3 Accessmode - NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-

3.6.2 users passwd

Use this command to change a password. Passwords are a maximum of eight
alphanumeric characters. If a user is authorized for authentication or encryption is
enabled, the password length must be at least eight alphanumeric characters. The
username and password are not case-sensitive. When you change a password, a prompt
asks for the old password. If there is no password, press enter.
Default
Format
Mode
3.6.2.1 no users passwd
This command sets the password of an existing user to blank. When you change a
password, a prompt asks for the old password. If there is no password, press enter.
Format
Mode

3.6.3 users snmpv3 accessmode

This command specifies the snmpv3 access privileges for the specified login user. The
valid accessmode values are
name for which the specified access mode applies. The default is
"admin" user and
Default
Format
Mode
3.6.3.1 no users snmpv3 accessmode
This command sets the snmpv3 access privileges for the specified user as readwrite for
the "admin" user and readonly for all other users. The
for which the specified access mode will apply.
Format
Mode
Administrative Access Commands
no password
users passwd <username>
Global Config
no users passwd <username>
Global Config
or
readonly
for all other users
readonly
admin - readwrite; other - readonly
users snmpv3 accessmode <username> {readonly |
readwrite}
Global Config
no users snmpv3 accessmode <username>
Global Config
v1.0, December 2005
. The
readwrite <username>
<username>
is the login user
for the
readwrite
value is the user name
3-19