Show Ip Bgp Damping - NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-

14.8.66 show ip bgp damping

This command displays all the information configured for BGP4 that relates to flap
parameters. You can configure all of the parameters in the output.
Format
Mode
Route Flap Mode
Suppress Limit
Reuse Limit
Penalty
Increment
Delta Time
Flap Max Time
Damping Factor
Reuse Size
Prefix/Len
State
Penalty Value
Decay
Decrement
Time Created
Time Suppressed
Event State
Routing Commands
show ip bgp damping {dampened-paths | flap-statis-
tics}
Privileged EXEC
This field indicates whether or not damping of the route flaps
is enabled.
This field displays the damping suppress limit for the route
flaps.
This field displays the reuse limit for the dampened routes.
This field displays the penalty increment for the route flaps.
This field is the delta time used for the dampened routes.
This field displays the maximum flap entry time for the route.
This field is the exponential decay factor for the flapped
routes.
This field displays the maximum reuse array size.
This field displays the prefix and the prefix length for the
entry in the route flap dampened table.
This field indicates whether the route is suppressed, not sup-
pressed, or reused.
This field indicates the accumulated penalty for the route.
This field indicates the decay decrement for the entry in the
route flag dampened table.
This field indicates the time that this entry was created.
This field indicates the suppressing time for this route
This field indicates the event state for this entry in the route
flap dampened table.
v1.0, December 2005
14-95