Show Port; Show Port Protocol - NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-

4.1.13 show port

This command displays port information.
Format
Mode
Interface
Type
Admin Mode
Physical Mode
Physical Status
Link Status
Link Trap
LACP Mode

4.1.14 show port protocol

This command displays the Protocol-Based VLAN information for either the entire
system, or for the indicated group.
Format
Mode
Group Name
Group ID
Port and System Setup Commands
show port {<slot/port> | all}
Privileged EXEC
Valid slot and port number separated by forward slashes.
If not blank, this field indicates that this port is a special type
of port. The possible values are:
Mon - this port is a monitoring port. Look at the Port Moni-
toring screens to find out more information.
Lag - this port is a member of a port-channel (LAG).
Probe - this port is a probe port.
Selects the Port control administration state. The port must be
enabled in order for it to be allowed into the network. - May
be enabled or disabled. The factory default is enabled.
Selects the desired port speed and duplex mode. If auto-nego-
tiation support is selected, then the duplex mode and speed is
set from the auto-negotiation process. Note that the maxi-
mum capability of the port (full duplex -100M) is advertised.
Otherwise, this object determines the port's duplex mode and
transmission rate. The factory default is Auto.
Indicates the port speed and duplex mode.
Indicates whether the Link is up or down.
This object determines whether or not to send a trap when
link status changes. The factory default is enabled.
Displays whether LACP is enabled or disabled on this port.
show port protocol {<groupid> | all}
Privileged EXEC
This field displays the group name of an entry in the Proto-
col-based VLAN table.
This field displays the group identifier of the protocol group.
v1.0, December 2005
4-7