Spanning-Tree Mst Instance - NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-
Default
Format
Mode
5.1.11.1 no spanning-tree mst
This command sets the Path Cost or Port Priority for this port within the multiple spanning
tree instance, or in the common and internal spanning tree to the respective default values.
If you specify an
instance, you are configuring that multiple spanning tree instance. If you specify 0
(defined as the default CIST ID) as the
internal spanning tree instance.
If the you specify cost, this command sets the path cost for this port within a multiple
spanning tree instance or the common and internal spanning tree instance, depending on
the parameter, to the default value, i.e. a path cost value based on the Link Speed.
<mstid>
If you specify external-cost, this command sets the external path cost for this port for mst
'0' instance, to the default value, i.e. a path cost value based on the Link Speed.
If you specify port-priority, this command sets the priority for this port within a specific
multiple spanning tree instance or the common and internal spanning tree instance,
depending on the
Format
Mode

5.1.12 spanning-tree mst instance

This command adds a multiple spanning tree instance to the switch. The parameter
is a number within a range of 1 to 4094, that corresponds to the new instance ID
<mstid>
to be added. The maximum number of multiple instances supported by the switch is 4.
Format
Mode
Spanning Tree Protocol Commands
cost: auto; external-cost: auto; port-priority: 128
spanning-tree mst
auto} |
{external-cost <1-200000000> | auto}| port-prior-
ity <0-240>}
Interface Config
parameter that corresponds to an existing multiple spanning tree
<mstid>
parameter, to the default value, i.e. 128.
<mstid>
no spanning-tree mst <mstid> <cost | external-cost
| port-priority>
Interface Config
spanning-tree mst instance <mstid>
Global Config
v1.0, December 2005
<
mstid> {{cost <1-200000000> |
, you are configuring the common and
<mstid>
5-7