Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-
Acceptable values are:
100h
100f
10h
10f
4.1.9 speed all
This command sets the speed and duplex setting for all interfaces.
Format
Mode
Acceptable values are:
100h
100f
10h
10f
4.1.10 monitor session
This command configures a probe port and a monitored port for monitor session (port
monitoring). To enable port monitoring, you must add a source interface, destination
interface, and enable the mode. If enabled, the probe port monitors all the traffic received
and transmitted on the physical monitored port.
Format
Mode
Port and System Setup Commands
100BASE-T half duplex
100BASE-T full duplex
10BASE-T half duplex
10BASE-T full duplex
speed all {<100 | 10> <half-duplex | full-duplex>}
Global Config
100BASE-T half-duplex
100BASE-T full duplex
10BASE-T half duplex
10BASE-T full duplex
monitor session <session-id> {source interface
<slot/port> | destination interface <slot/port> |
mode}
Global Config
v1.0, December 2005
4-5