Vlan Show Commands; Show Vlan - NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-

6.2 VLAN Show Commands

This section describes the commands you use to view VLAN settings.

6.2.1 show vlan

This command displays detailed information, including interface information, for a
specific VLAN. The ID is a valid VLAN identification number.
Format
Modes
VLAN ID
VLAN Name
VLAN Type
Interface
Current
VLAN Commands
show vlan <vlanid>
Privileged EXEC
User EXEC
There is a VLAN Identifier (VID) associated with each
VLAN. The range of the VLAN ID is 1 to 4094.
A string associated with this VLAN as a convenience. It can
be up to 32 alphanumeric characters long, including blanks.
The default is blank. VLAN ID 1 always has a name of
"Default." This field is optional.
Type of VLAN, which can be Default (VLAN ID = 1) or
static (one that is configured and permanently defined), or
Dynamic (one that is created by GVRP registration).
Valid slot and port number separated by forward slashes. It is
possible to set the parameters for all ports by using the selec-
tors on the top line.
Determines the degree of participation of this port in this
VLAN. The permissible values are:
Include - This port is always a member of this VLAN. This is
equivalent to registration fixed in the IEEE 802.1Q standard.
Exclude - This port is never a member of this VLAN. This is
equivalent to registration forbidden in the IEEE 802.1Q stan-
dard.
Autodetect - Specifies to allow the port to be dynamically
registered in this VLAN via GVRP. The port will not partici-
pate in this VLAN unless a join request is received on this
port. This is equivalent to registration normal in the IEEE
802.1Q standard.
v1.0, December 2005
6-11