Disable Ip Multicast Mdebug Mtrace; Mrinfo - NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-
15.1.4.1 no ip multicast ttl-threshold
This command applies the default <
<
ttlthreshold>
which are to be forwarded from the interface
Format
Mode

15.1.5 disable ip multicast mdebug mtrace

This command is used to disable the processing capability of mtrace query on this router.
If the mode is enable, the mtrace queries received by the router are processed and
forwarded appropriately by the router. If the mode is disable, this router does not respond
to the mtrace queries it receives from other router devices.
Default
Format
Mode
15.1.5.1 no disable ip multicast mdebug mtrace
This command is used to enable the processing capability of mtrace query on this router. If
the mode is enable, the mtrace queries received by the router are processed and forwarded
appropriately by the router. If the mode is disable, this router does not respond to the
mtrace queries it receives from other router devices.
Format
Mode

15.1.6 mrinfo

This command is used to query the neighbor information of a multicast-capable router
specified by
[ipaddr]
command is issued. The mrinfo command can take up to 2 minutes to complete. Only one
mrinfo command may be in process at a time. The results of this command will be
available in the results bufferpool which can be displayed by using
Default
Format
Mode
15-4
ttlthreshold>
is the TTL threshold which is to be applied to the multicast Data packets
no ip multicast ttl-threshold
Interface Config
none
disable ip multicast mdebug mtrace
Global Config
no disable ip multicast mdebug mtrace
Global Config
. The default value is the IP address of the system at which the
none
mrinfo [<ipaddr>]
Privileged EXEC
v1.0, December 2005
to a routing interface. The
.
IP Multicast Commands
.
show mrinfo