Users Snmpv3 Authentication; Users Snmpv3 Encryption - NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-

3.6.4 users snmpv3 authentication

This command specifies the authentication protocol to be used for the specified user. The valid authentication
protocols are none, md5 or sha.
the snmpv3 authentication password and therefore must be at least eight characters in
length. The
<username>
Default
Format
Mode
3.6.4.1 no users snmpv3 authentication
This command sets the authentication protocol to be used for the specified user to none.
The
<username>
Format
Mode

3.6.5 users snmpv3 encryption

This command specifies the encryption protocol used for the specified user. The valid
encryption protocols are
If you select
des
key must be 8 to 64 characters long. If you select the
key, the user is prompted for the key. When you use the
is also used as the snmpv3 encryption password, so it must be a minimum of eight
characters. If you select
The
<username>
Default
Format
Mode
3-20
If you specify
is the user name associated with the authentication protocol.
no authentication
users snmpv3 authentication <username> {none | md5
| sha}
Global Config
is the user name for which the specified authentication protocol is used.
users snmpv3 authentication <username>
Global Config
or
des none.
, you can specify the required key on the command line. The encryption
, you do not need to provide a key.
none
value is the login user name associated with the specified encryption.
no encryption
users snmpv3 encryption <username> {none |
des[key]}
Global Config
v1.0, December 2005
or , the login password is also used as
md5 sha
protocol but do not provide a
des
protocol, the login password
des
Administrative Access Commands