Snmp-Server Community; Snmp-Server Community Ipaddr - NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-

10.1.2 snmp-server community

This command adds (and names) a new SNMP community. A community
name associated with the switch and with a set of SNMP managers that manage it with a
specified privileged level. The length of
Note: Community names in the SNMP Community Table must be unique. When
Default
Format
Mode
10.1.2.1 no snmp-server community
This command removes this community name from the table. The
community name to be deleted.
Format
Mode

10.1.3 snmp-server community ipaddr

This command sets a client IP address for an SNMP community. The address is the
associated community SNMP packet sending address and is used along with the client IP
mask value to denote a range of IP addresses from which SNMP clients may use that
community to access the device. A value of 0.0.0.0 allows access from any IP address.
Otherwise, this value is ANDed with the mask to determine the range of allowed client IP
addresses. The name is the applicable community name.
Default
Format
Mode
10-2
making multiple entries using the same community name, the first entry is
kept and processed and all duplicate entries are ignored.
public and private, which you can rename; default values for
the remaining four community names are blank
snmp-server community <name>
Global Config
no snmp-server community <name>
Global Config
0.0.0.0
snmp-server community ipaddr <ipaddr> <name>
Global Config
v1.0, December 2005
can be up to 16 case-sensitive characters.
<name>
is a
<name>
is the
<name>
SNMP Commands