Network Protocol; Show Network - NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-
3.1.5.1 no network mgmt_vlan
This command sets the Management VLAN ID to the default.
Format
Mode

3.1.6 network protocol

This command specifies the network configuration protocol to be used. If you modify this
value, change is effective immediately. If you modify this value, the change is effective
immediately. If you use the
BootP server until a response is received. If you use the
periodically sends requests to a DHCP server until a response is received. If you use the
parameter, you must configure the network information for the switch manually.
none
Default
Format
Mode

3.1.7 show network

This command displays configuration settings associated with the switch's network
interface. The network interface is the logical interface used for in-band connectivity with
the switch via any of the switch's front panel ports. The configuration parameters
associated with the switch's network interface do not affect the configuration of the front
panel ports through which traffic is switched or routed.
Format
Modes
IP Address
Subnet Mask
Default Gateway
Burned In MAC
Address
Administrative Access Commands
no network mgmt_vlan
Privileged EXEC
parameter, the switch periodically sends requests to a
bootp
none
network protocol {none | bootp | dhcp}
Privileged EXEC
show network
Privileged EXEC
User EXEC
The IP address of the interface. The factory default value is
0.0.0.0
The IP subnet mask for this interface. The factory default
value is 0.0.0.0
The default gateway for this IP interface. The factory default
value is 0.0.0.0
The burned in MAC address used for in-band connectivity.
v1.0, December 2005
parameter, the switch
dhcp
3-3