Show Ip Ssh; Hypertext Transfer Protocol (Http) Commands; Ip Http Secure-Port; Section 3.5 "Hypertext Transfer Protocol (Http) Commands - NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-

3.4.5 show ip ssh

This command displays the ssh settings.
Format
Mode
Administrative
Mode
Protocol Level
Connections This field specifies the current SSH connections.

3.5 Hypertext Transfer Protocol (HTTP) Commands

This section describes the commands you use to configure HTTP access to the switch.
Access to the switch by using a Web browser is enabled by default. Everything you can
view and configure by using the CLI is also available by using the Web.

3.5.1 ip http secure-port

This command is used to set the SSL port where port can be 1-65535 and the default is
port 443.
Default
Format
Mode
3.5.1.1 no ip http secure-port
This command is used to reset the SSL port to the default value.
Format
Mode
Administrative Access Commands
show ip ssh
Privileged EXEC
This field indicates whether the administrative mode of SSH
is enabled or disabled.
The protocol level may have the values of version 1, version
2 or both versions 1 and version 2.
443
ip http secure-port <portid>
Privileged EXEC
no ip http secure-port
Privileged EXEC
v1.0, December 2005
3-15