Show Ip Igmp Groups - NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-
IGMP Admin
Mode
Interface
Interface Mode
Protocol State

15.5.11 show ip igmp groups

This command displays the registered multicast groups on the interface. If
specified this command displays the registered multicast groups on the interface in detail.
Format
Mode
If you do not use the
IP Address
Subnet Mask
Interface Mode
The following fields are not displayed if the interface is not enabled:
Querier Status
Groups
If you use the
Multicast IP
Address
Last Reporter
IP Multicast Commands
This field displays the administrative status of IGMP. This is
a configured value.
Valid slot and port number separated by forward slashes.
This field indicates whether IGMP is enabled or disabled on
the interface. This is a configured value.
This field indicates the current state of IGMP on this inter-
face. Possible values are Operational or Non-Operational.
show ip igmp groups <slot/port> [detail]
Privileged EXEC
keyword, the following fields appear:
detail
This displays the IP address of the interface participating in
the multicast group.
This displays the subnet mask of the interface participating in
the multicast group.
This displays whether IGMP is enabled or disabled on this
interface.
This displays whether the interface has IGMP in Querier
mode or Non-Querier mode.
This displays the list of multicast groups that are registered
on this interface.
keyword, the following fields appear:
detail
This displays the IP Address of the registered multicast group
on this interface.
This displays the IP Address of the source of the last mem-
bership report received for the specified multicast group
address on this interface.
v1.0, December 2005
is
[detail]
15-33