Show Radius Statistics - NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-
Bad
Authenticators
Pending
Requests
Timeouts
Unknown Types
Packets Dropped

11.2.10 show radius statistics

This command is used to display the statistics for RADIUS or configured server. To show
the configured RADIUS server statistic, the IP Address specified must match that of a
previously configured RADIUS server. On execution, the following fields are displayed.
Format
Mode
If you do not specify an IP address, then only the Invalid Server Address field is displayed.
Otherwise other listed fields are displayed.
Invalid Server
Addresses
Server IP
Address
Round Trip Time
Access Requests
Access
Retransmission
Port-Based Access and Authentication Commands
The number of RADIUS Accounting-Response packets con-
taining invalid authenticators received from this accounting
server.
The number of RADIUS Accounting-Request packets sent to
this server that have not yet timed out or received a response.
The number of accounting timeouts to this server.
The number of RADIUS packets of unknown types, which
were received from this server on the accounting port.
The number of RADIUS packets received from this server on
the accounting port and dropped for some other reason.
show radius statistics [ipaddr]
Privileged EXEC
The number of RADIUS Access-Response packets received
from unknown addresses.
IP Address of the Server.
The time interval, in hundredths of a second, between the
most recent Access-Reply, Access-Challenge and the Access-
Request that matched it from the RADIUS authentication
server.
The number of RADIUS Access-Request packets sent to this
server. This number does not include retransmissions.
The number of RADIUS Access-Request packets retransmit-
ted to this RADIUS authentication server.
v1.0, December 2005
11-19